Methods to paint rc automotive our bodies

 It’s time for a brand new look! As an alternative of reaching for one more original-equipment physique, why not go for a brand new look with an aftermarket shell and your individual distinctive paint job? Methods to paint rc automotive our bodies ,All you’ll have to get gorgeous outcomes are a number of cans of spray paint and masking tape.


Step 1: Mark the body-post areas
Place the physique over the chassis, line up the wheels with the wheel wells, and mark the spots the place the physique posts contact the shell. You can also make a dent with the tip of your pastime knife to mark the spot, or use a permanent-ink marker.

[amazon_link asins=’B01N4W4PTS’ template=’ProductAd’ store=’newsales2018-20′ marketplace=’US’ link_id=’24956bf7-fb5a-11e7-8d37-2b1b8ca5278c’]

Look immediately down on the publish to make sure that you simply mark the opening areas exactly.

[amazon_link asins=’B010NBJ0TM,B00K5GO8FM,B00L6K89CE’ template=’ProductGrid’ store=’newsales2018-20′ marketplace=’US’ link_id=’00e95e66-f5e1-11e7-9d8d-252f3eddce72′]

Step 2: Wash the physique
Though your crystal-clear physique appears completely clear, it little doubt has fingerprints and mud on its internal floor. Water and dish cleaning soap are all you’ll want to scrub it. Once you’ve completed, dry the physique completely with a lint-free towel.


Don’t skip this step—until, after all, you desire a huge ol’ thumbprint on the hood!


Step three: Apply the window masks
Nearly all our bodies now embrace precut window masks; simply peel and stick them into place. You should definitely rub the sides of the masks down fully in order that they tightly seal out the paint.


Use your thumbnail or the sting of a bank card to massage the sides of the masks.


Step four: Masks The design
You’ll be able to sketch on the physique with a permanent-ink marker; the strains are straightforward to take away with denatured alcohol. Once you’ve settled on a design, tape off the areas that will probably be painted the lighter coloration. Once you paint, all the time apply the darkest coloration first; that method, it gained’t bleed by the lighter coloration.


This physique is prepared for paint; the masked space will probably be white, so I’ll paint that final.


Step 5: Paint!
Shake the paint can completely, maintain it about 10 inches away from the physique, and spray in clean strokes. Cease spraying after every stroke; in case you maintain the button down nonstop, you’ll waste loads of paint and simply create a choking cloud of overspray. Until you’re portray a metallic or sweet coloration, one coat must be sufficient, however in case you discover any skinny spots, you may apply a second coat after the primary one has dried.


Spray backward and forward, and cease between strokes. Just a few skinny coats are higher than one or two thick coats. Don’t “scribble” the physique; you’ll get uneven protection, or worse, runs
and drips.


Step 6: Take away the masking & apply the second coloration
After the paint has dried fully, peel off the masks (however depart the window masks on) and paint the second coloration. Permit it to dry fully, and recoat if mandatory.


Virtually completed. When it has been trimmed and decaled, the physique will actually come to life.


Step 7: The massive end
When all of the paint is totally dry (to be secure, wait a number of hours), peel off the window masks. As an alternative of choosing on the edges together with your fingernail, use a pastime knife to elevate a nook of the masks; you don’t wish to scratch your new paint job. You can too peel off the overspray movie (take a look at that shine!) and apply the decals; now your paint job will actually come to life.


Completed! A bit pink pinstriping tape clothes up the white-blue break for a high-contrast look.